Panacom PA-7600 Manual Del Usuario página 5

note: After setting auto IP function, when calling back or predialing,if
the first digit of the number is "0",the phone will dial out the IP No
first automatically.
setting Pulse/tone dialing Mode
After setting AUTO IP,the LCD will show "SET 5 P-T"
Press SET to enter into the menu
The LCD will show: TONE -,
Use UP or DN button to change the setting to pulse dialing mode.
Then press SET button to confirm and go to next setting.
setting alarM
After setting P-T dialing mode,the LCD will show "SET 6 ALARM"
Press SET to enter into the menu
The LCD will show: ALARM OFF,
Use UP or DN button to trun on/off the alarm setting.
Press the SET to confirm and go to set up next setting.
setting alert tiMe
After setting alarm,the LCD will show "SET 7 ALERT"
Press SET to enter into the menu
The LCD will show: 1 00-00 OFF (First alarm,HH-MM,off/on),
Use UP or DN button to choose the first/second/third alarm press
SET to enter the setting. Press UP or DN to adjust the alarm time.
Press the SET to confirm and go to next setting.
note: When the alarm is on,it will keep on ringing for 1 minute,press
any button to stop ringing.
The first and second alarm is one-off setting.the third one is permanent.
setting lcd
After setting the alarm,the LCD will show "SET 8 LCD".
Press SET to enter into the menu.
The LCD will show: LCd 3
Use UP or DN button to change the LCD brightness.
Press SET to confirm and press DEL to exit.
Total: 5 levels
Pg. 5