Retekess TD175 Manual página 4

2. Pager
2.1 Diagram
2.2 Specification
Extension size
Case material
Modulation mode
Receiving frequency
Receiving sensitivity
Battery
Standby current
Alarm current
Alert mode
Standby time
Communication distance
Prompt duration
3. Operating instructions
3.1 Preparation before use
Before setting up the following operations. make sure that
the antenna of the transmitting host is connected to the
antenna connector in the correct way and the power
supply is correctly plugged into the host connector.
It is recommended to charge the menu for ten minutes for
the first use of the menu.
3.2 Power on
Insert the pager into the charging slot on the mainframe when it is in the off state. and the pager will be turned on automatically. After
taking out the pager. the indicator light flashes slowly to enter the standby state. at this time you can call the paired pager through the
transmitting host.
1
1. Pager number label
2. Charging contact port
2
95*51*11mm
ABS
OOK (AM)
433.92Mhz
-108dBm
Lithium battery 200mAh
10mA
90mA
Buzzer/flashing light/vibration
20h
500M (open distance)
1-999 seconds can be set
The menu indicator (2 LEDs) flashes fast to indicate that
charging is in progress. and the indicator (2 LEDs) lights
up normally to indicate that charging is complete.
02