VEVOR JX-DC-10 Manual De Instrucciones página 12

Step 3:
Repeat step 2 until the bottom circle is created as shown.
Step 4:
Take 3x pole (part B).
Connect them with 1x bolt (part E), 1x nut (part K), 1x washer (part H). The order
of the poles must correspond to the order shown in the figure.
First put a washer over the bolt. Then insert the bolt from the inside through pole
1, then pole 2, then pole 3, then pole 4, then pole 5, then screw the nut onto the
bolt hand-tight.
Make sure that the poles are always aligned counterclockwise.
10