VEVOR JX-DC-10 Manual De Instrucciones página 5

OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe operation
of the system.
To ensure safety, do not attempt to assemble this product without following the
instructions carefully.
Check entire box and inside all packing material for parts and/or additional
instruction material. Before beginning assembly, read the instructions and identify
parts using the hardware identifier and parts list in this document. Proper and
complete assembly, use and supervision are essential for proper operation and to
reduce the risk of accident or injury. A high probability of serious injury exists if this
product is not installed, maintained and operated properly.
· If using a ladder during assembly, use extreme caution.
· Two capable adults are recommended for this operation.
· Be aware that parts can be damaged by over tightening the screws.
· Wear safety glasses throughout the assembly.
Most injuries are caused by misuse and/or not following instructions. Use caution
when using this product.
BEFORE BEGINNING ASSEMBLY
Keep the hardware bags and their contents separate.
Identify and inventory all parts and hardware using the parts and hardware lists
and identifiers in this document. Test fit all Bolts by inserting them into their
respective holes. Do not scrape away all of the powder coating. Bare metal may
rust. You may need to pound some Bolts into place with a hammer or mallet.
*Two adults required to complete assembly*
Only adults should set up the product. Do not allow children in the setup
area until assembly is complete.
INSTALLATION & GROUND PREPARATION INSTRUCTIONS:
· Provide enough room so that children can use the equipment safely. For example,
for structures with multiple play activities, a slide should not exit in front of a swing.
· Separate active and quiet activities from each other. For example, locate
3