Publicidad
Idiomas disponibles
Idiomas disponibles
grease.
Disconnect tools.
When not in use, before servicing and when changing accessories such as blades,
bits and cutters.
Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are removed
from the tool before turning it on.
Alvord unintentional starting.
Do not carry a plugged-in toot with a nger on the switch. Ensure switch, is off when
plugging in.
Use outdoor extension leads.
When tool is used outdoors, use only extension cords intended for outdoor use.
Stay alert.
Watch what you are doing, Use common sense. Do not operate tool when you are
tired.
Check damaged parts.
Better further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it would operate properly and perform its
intended function. Check for alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other conditions that may affect its
operational. A guard or other part char is damaged could be properly repaired or
replaced by an authorized service center unless otherwise indicated in this instruc-
tion manual. Have defective switches replaced by an authorized service facility. Do
not use the tool if the switch does not turn it on and off.
Warning.
The use of any accessory or attachment, other than those recommended, in this
instruction manual, may present a risk of personal injury.
4
This electric tool is in accordance with the relevant safety requirements. Repairs
should only be carried out by quali ed persons using original spare parts, otherwise
this may result in considerable danger to the user.
Safety Instructions
for Spray Guns
You may only spray coating materials such as paints, varnishes, glazes, etc. with a
fashpoint of 21°C (32°C in UK) and higher without additional warning. (German
classifcation of coating material is hazard classes A II and A III, see material tin.)
The device may not be used in workplaces covered by the explosion-protection
regulations.
There must be no sources of ignition such as, for example, open fres, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
Do not spray any substances whose hazard potential is not known.
Before working on the spray gun remove the power plug from the socket.
Do not use the spray guns to spray ammable substances.
The spray guns are not to be cleaned with ammable solvents which have a ashpoint
under 21°C.
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the speci cations given by the substance
manufacturer.
Recommendation: Wear a breathing mask and safety glasses when spraying.
Safety
Instructions
5
Publicidad
