Chimney Assembly; Refitting The Metallic Filters; Plastic Reducer - steel K Serie Manual De Uso

10 Installation

Chimney assembly

• Move part "G" towards the hood until fully inserted.
• Screw part "G" to the hood using the self-tapping
screws "N".
• Slide the telescopic component "H" to reach the
required height.
• Mark the wall at the position of the two holes "Q" in the
mounting bar "L".
• Lower the telescopic component "H" and remove the
mounting bar "L" by unscrewing the two screws "M".
• Move the mounting bar "L" to the wall in line with the
previously marked holes.
• Use a spirit level to check the horizontal alignment and
drill the holes.
• Insert two 6 mm toggle bolts and fasten the mounting
bar "L" to the wall.
• Screw the telescopic component "H" to the mounting
bar "L" with the screws "M".
L
M
Q
L
Q
If previously disconnected, reconnect the
connector "B" to the suction motor.
H
M
M M
G
H
G
N
B

Refitting the metallic filters

Reposition the filters by introducing first the guides "P"
into the rear slots, then push the filters up and lock them
in position by closing the splines "A".

Plastic reducer

The motor exhaust union has a diameter of 15 cm. The
hoods are fitted with a 12 cm plastic reducer.
12 cm
A
P