Publicidad
Idiomas disponibles
Idiomas disponibles
11
MOUNT THE UTC
Place the hood onto the partially installed
screws using the keyholes and slide the hood
back into position.
1
Mounting screw (4)
Keyhole (4)
12
SECURE HOOD
Tighten the mounting screws. Be sure the
screw heads are in the narrow neck of the
keyhole slot.
Keyhole (4)
13
CONNECT DUCTWORK TO HOOD
(Ducted installations only)
Connect ducting to hood. Use duct tape to
make joints secure and airtight.
16
Installation Instructions
2
Mounting
screw (4)
14
ELECTRICAL CONNECTION
1.
Connect the Power Supply Cable to the range
hood. Attach the white lead of the power
supply to the white lead of the range hood
(A) with a wire nut (C). Attach the black lead
of the power supply to the black lead of the
range hood (B) with a wire nut (C). Connect
the green (D) ground wire under the green
grounding screw.
2.
Replace the hood junction box.
B
D
15
OPTIONAL POWER CORD KIT
JXHC1
An optional Power Cord Connection Kit, model
JXHC1, is available at extra cost from your
GE Appliances supplier for installation using a
standard 3-prong, grounded wall outlet. Follow
the Installation Instructions packed with the kit
to connect the power cord to the range hood.
C
L
7
3 4
NOTE: If using optional Power Cord Kit
JXHC1, feed the power cord through the hole
in the top cabinet while raising the hood. Loop
any excess length of cord and tie away with a
suitable tape or tie.
C
A
Cabinet
3-prong
wall outlet
(if using cord
connection)
1
1 4
1
3 4
for optional power
supply location
49-2001094 Rev. 0
Publicidad
