Publicidad
Idiomas disponibles
Idiomas disponibles
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-38°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
12°C/12-20°C. The ambient temperature has an impact on the interior temperature and humidity of your
cellar. For optimal operation, the settings of your cellar are made for ambient temperatures of 23°C to 25°C.
Temperature setting
A
ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
B
Decrease temperature of 1 degree Celsius or Fahrenheit.
C
Raise temperature of 1 degree Celsius or Fahrenheit.
Display shows upper zone temperature at its setting.
D
E
Temperature display in Celsius.
F
Temperature display in Fahrenheit.
Display shows lower zone temperature at its setting.
G
Compartment selecting switch (lower or upper one). Once the compartment has been
selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
H
temperature will be showing
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
J
Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone
is adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But for
optimal performance, once one zone is set at 12ºC, we suggest another setting for the other zone
with 3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature
difference between both compartments is 10°C. Always set cooler temperature in the upper
compartment and warmer temperature in the lower compartment (example: 5°C upper and 15°C
lower).
• To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to
switch it to lower zone. Setting temperature could only be set under display flash status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
for upper zone and
43
for lower zone.
Publicidad
