Descargar Imprimir esta página

Orbegozo CP 10035 Manual De Instrucciones página 12

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

CP 10035
PARTS IDENTIFICATION & ASSEMBLY
1. Power cord (from roof)
2. Safety rope
3. Assembly bracket
4. Screws for roof (taping screw 4 pcs or expansión bolt
screws 4 sets)
5. Screws (M4*10, 2 pcs).
6. Motor set
7. Fan blade
8. Blade cap
9. LED lamp housing
10. Grill
11. Grill decoration cap
Fan assembly:
Ceiling installation and electrical connection must be done
by a licensed electrician. Improperly installed ceiling fans can
be dangerous.
Important:
The intended installation point (on the ceiling) must be strong enough to withstand the weight of
-
the fan, as well as the strong forces during its movement (at least 4x the weight of the fan.)
An additional disconnection switch must be included in the fixed wiring, in close proximity to the
-
ceiling fan to isolate the source for maintenance or repairs.
Before installing the fan, make sure you have turned off the main electricity supply. Do not turn it
-
back on until the fan is fully installed and ready to use.
It is essential that blades are to be installed no less than 2.4 meters (7.87 feet) above the floor, and
-
that adequate clearance exists between the blades and adjacent walls, furnishings, etc.
2) Disconnect the safety rope [2] from the Assembly bracket [3] by screwing it
counterclockwise. Before the next step, let the power cord [1] go through
the hole of the Assembly bracket.
1) Release the 2 Meson Screw [5] at the motor set with tools and
take out the Assembly bracket [3] by pressing and turning
counterclockwise.
12

Publicidad

loading