Orbegozo CP 10035 Manual De Instrucciones página 13

CP 10035
4) Insert the power cord [1] from roof to the terminal block with correct wire
connection as the picture.
NOTE: The power cord end should be stripped 8-10 mm.
OPERATION
Ensure that the length of supply cord between the terminal block and roof which is more than the
-
length of safety rope (120 mm)
Make sure that the fan is fully assembled (and that the grills are in place and locked) before
-
switching on.
The input power could not be controlled by the ordinary speed control switch, it can only be
-
controlled by general rocker switch (wall switch).
Mode switching by general rocker switch (Wall switch control):
1. Press the rocker switch once at "ON" status: LED light is turned on in Natural white, 100% brightness.
2. Press the rocker switch twice at "ON" status: Fan is turned on in high setting mode with 360o
oscillation.
3. Press the rocker switch a third time at "ON" status: LED light is turned on in Natural white, 100%
brightness; fan is turned on in high setting mode with 360º oscillation.
NOTE: this function is only valid if each pressing within 3 seconds.
3) Fix the Assembly bracket [3] to the roof with the screws in the packing
accessory. Connect the safety rope [2] again to the Assembly bracket.
NOTE: 2 types of screws are provided for different roof.
Woody roof: Tapping screws (M5*40, 4 pcs)
Concrete roof: Expansion bolts & screws (M6*30, 4 sets)
5) Match the slot of the Motor set [6] to the buckle of the Assembly
bracket, screw the motor set to a right position, now the safety rope cap
is at the correct location of the slot. Fixing the motor set with 2 pcs
Meson screws [5].
13