Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Replacing the interior light bulb
(Item 11)
In case that the light bulb is out of function it is
easily to replace. First make sure that the
refrigerator / freezer is disconnected from the
power supply by removing the plug. Take a flat
screwdriver and keep it carefully without force into
the left gap between lamp cover and internal
cabinet. Then press the handle of the screwdriver
carefully to the left side until you notice that the left
pin of the cover is disengaged . Repeat this
procedure on the right gap, however now press
the handle of the screwdriver carefully to the right
side. If both sides are loosened the cover can be
removed easily.
Ensure that bulb is screwed securely in the bulb
holder. Plug the appliance into the power supply. If
the light still fails, replace E14 screw-cap type 15
Watt (Max) bulb from your local electrical store
and then fit it. Carefully dispose of the burnt-out
light bulb immediately.
If you have changed the light bulb please fix the
cover again in it's former position. Take care that
the cover snaps-in correctly.
Cleaning and care
Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch
off the circuit breaker before cleaning.
Clean the exterior using lukewarm water and a
mild detergent.
Never use detergents, abrasive or acidic agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.
If the device is not going to be used for a
long period of time, unplug the power cable and
remove all food. Clean the appliance and keep the
door open.
To preserve the appearance of your appliance,
you can polish the exterior and the door
accessories with a silicone wax.
Clean the condenser at the back of the appliance
once a year using a brush or a vacuum cleaner.
Dust build-up leads to increased energy
consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.
Cleaning of the accessories
Door shelves:
Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it off
sideward.
Remove the bottom of the door shelf by pushing it
upwards.
Collecting container (Pan):
Make sure that the pan at the back of the
appliance is always clean.
Gently release the snap of the pan from the
compressor by pushing it using a tool (like
screwdriver), so that the pan can be removed.
Lift the pan, clean it and wipe it dry.
Re-assemble in reverse order.
Crisper or Drawers:
To clean a drawer, pull it out as far as possible, tilt
it upwards and then pull it out completely
(Item 7-8).
Practical tips and notes
Cooling
• Clean fresh food and vegetables before storing
in the crisper bin.
• Always pack or wrap food, or put it in a suitable
container, before storing it in the appliance.
• Wrap food which is not suitable for storage at
cold temperatures in polyethylene bags
(pineapple, melons, cucumbers, tomatoes etc.).
• Food with strong odour or apt to acquire odour
should be wrapped in airtight or smellproof
packaging material.
• Keep fresh food separate from cooked food, to
avoid bacteria contamination.
• Never keep fresh meat in the fridge for more
than 2 or 3 days.
• Remove any left-over canned food from the can
and store it in a suitable container.
• Refer to the shelf life indicated on the food
packaging.
• Do not obstruct the air circulation inside the
device by covering the shelves.
• Never keep any dangerous or poisonous
substances inside your device.
• Always check food that has been stored for a
long period of time for its suitability for
consumption.
• Do not store fresh and cooked food together in
the same container.
• Close the door immediately after opening, to
avoid unnecessary energy consumption.
• Do not use hard or sharp objects to remove the
ice build-up.
• Do not load hot food into your appliance.
7
Instruction for use
Publicidad
