Assembly; Front Wheel - Greencut GTC180X Manual De Instrucciones

58

ASSEMBLY

SPUR INSTALLATION
1. Connect the drag spur to the support of the drag bar, choose a
suitable height and then lock the drag bar with the large locking
pin of type R.
MOUNTING AND ADJUSTMENT OF THE HANDLEBAR
1. Slide the handlebar bracket over the ends of the handlebar bars.
2. Fasten the handlebar bars to the bracket with the screws provided and tighten with your fingers.
3. Slide the handles upwards and slide the bracket downwards on the tiller bracket. Insert the screw and fix it.
4. Insert the screws through the top holes and tighten.
1
5. To adjust the handlebar height, loosen the adjusting screws on
both sides, select the proper height and tighten the screw.

FRONT WHEEL

1. Pull the front wheel down so that the front wheel can rotate freely,
then lift the front wheel bracket to a suitable position and the front
wheel bracket will automatically be secured by the spring. The
rotary tiller can stand without any other support.
2. Quite la suciedad del área del silenciador y del tirador de arranque.
3
1
4
5
1
1
2