Vetus MPE1MB Manual De Instalación página 6

ENGLISH
1 Safety
Warning indications
The following warning indications are used in this manual in the con-
text of safety:
Indicates that great potential danger exists that can lead to serious
injury or death.
Indicates that a potential danger that can lead to injury exists.
Indicates that the usage procedures, actions etc. concerned can re-
sult in serious damage to property. Some CAUTION indications also
advise that a potential danger exists that can lead to serious injury
or death.
Emphasises important procedures, circumstances etc.
Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Pass on the safety instructions to others using the E-LINE motor.
General rules and laws concerning safety and accident prevention
must always be observed.
This product should only be installed and maintained by
qualified personnel who have read and understood the in-
structions and precautions in this manual. Failure to follow
the instructions in this manual may result in serious injury or
property damage. The manufacturer shall not be liable for any
damages resulting from improper installation or maintenance
by unqualified personnel.
6
370601.11
D
anGer
W
arninG
c
aution
n
ote
W
arninG
2 Introduction
This manual gives guidelines for installing a VETUS MPE1MB E-DRIVE
key switch
For operation, refer to the user manual.
The quality of the installation is decisive for the reliability of the
E-DRIVE system. Almost all faults can be traced back to errors or inac-
curacies during installation. It is therefore imperative that the steps
given in the installation instructions are followed in full during the
installation process and checked afterward.
Unauthorised modifications shall exclude the liability of the manu-
facturer for any resulting damage.
• During use ensure the correct battery voltage is available.
Changing over the plus (+) and minus (-) connections will
cause irreparable damage to the installation.
Never work on the electrical system while it is energized.
3 Installation
3.1 Placement
Always place the panel in such a place that the skipper has a good
view of it.
When the panel is installed low in the cockpit, place the panel in such
a way that no damage can be caused to the key (e.g. by feet).
Please note that the panel is only waterproof on the control side. The
back of the motor panel should be installed in a well protected and
ventilated area. Do not install the panel in a place where strong vibra-
tions could occur.
The panel must be placed in a flat plate.
• Make a hole of the correct size and fit the panel. Make sure the
gasket is properly positioned between the engine panel and the
bulkhead.
See principal dimensions page 26
Installation manual MPE1MB E-LINE Monitoring Panel
W
arninG
W
arninG