T-Mech MINI GARDEN TILLER Manual De Instrucciones página 10

3. Insert the pin into the hole that will achieve the desired depth.
USER GUIDE
ASSEMBLY INSTRUCTIONS
Adjusting the wheels:
ASSEMBLING THE WHEELS
The wheels on the Mini Tiller can be adjusted to one of three positions. The
The wheels on the Mini Tiller can be adjusted to one of three positions. The lowest wheel
lowest wheel position is used to transport the Mini Tiller when the engine is
position is used to transport the Mini Tiller when the engine is not running. The two higher
not running. The two higher positions are used when cultivating the soil and
positions are used when cultivating the soil and help to stabilise the unit when cultivating
help to stabilise the unit when cultivating at different depths.
at different depths.
1. Pull the locking metal sleeve against the spring until the wheel releases from one of the
1. Pull the locking metal sleeve against the spring until the wheel releases
three grooves.
from one of the three grooves.
2. Slide the wheel set up or down to the desired position, and release the locking metal
2. Slide the wheel set up or down to the desired position, and release the
sleeve until it locks into one of the three grooves.
locking metal sleeve until it locks into one of the three grooves.
Locking metal sleeve
Spring
10
Pin
Drag Stake/Pointed tip
Highest position
Middle position
Lowest position