Selecting 12/24-Hour Clock Mode (Mode); Switching The Alarm On/Off And Adjusting The Alarm Time (Alarm) - Bosch Rotterdam UBT40 Instrucciones De Manejo

Time
f Press the MENU 5 button, repeatedly if
necessary, to close the menu.
Selecting 12/24-hour clock mode
(MODE)
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "MODE" appears on the display along
with the current setting.
f Turn the volume control 1 counterclock-
wise or clockwise to change between the
settings.
f Press the MENU 5 button, repeatedly if
necessary, to close the menu.
Switching the alarm on/off and
adjusting the alarm time (ALARM)
You can set an alarm time on the device for a
one-off alarm. When the set time is reached, an
alarm signal will sound for about 15 seconds
and "ALARM" will flash on the display.
Afterwards, the device switches back to its
normal operating mode or switches off again.
Note:
To cancel the alarm before it
f
goes off, press any button (other
than the On/Off button 3 ). The
device then switches to normal
operating mode.
The alarm will also sound if the
f
device is already switched on at
the time that the alarm is
supposed to sound.
Robert Bosch Car Multimedia GmbH
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "ALARM" appears on the display
along with the current setting, "ON" or
"OFF".
f Turn the volume control 1 counterclock-
wise or clockwise to switch the alarm on/
off.
If "ALARM ON" is selected, the menu for setting
the time will be displayed after about 2
seconds.
f Enter the alarm time as described in the
"Setting the time" section.
f Press the MENU 5 button, repeatedly if
necessary, to close the menu.
7 620 000 142/143 | 05.2014
en | 43