GE GDT225 Serie Manual Del Propietário página 16

Troubleshooting Tips... Before you call for service
Problem
Sanitized light does
not illuminate at the
end of the cycle
Noise
A white film on
glassware, dishware
and the interior
Forget to Add a Dish?
Additional items may be added to the dishwasher at any time, ideally items would be added shortly after starting a
wash cycle.
1
Open the door to interrupt the cycle. Pull the door
handle to release the door.
2
Do not open the door all the way until the water spray
action stops. Steam may rise out of the dishwasher.
16
Possible Cause
The door was opened and
the cycle was interrupted
during final rinse
The incoming water
temperature was too low
Normal operating sounds:
Beeping at the end of the
cycle
Detergent cup opening
Water entering dishwasher
Motor stops and starts at
various times during cycle
Spray arms start and stop
at various times
Drain pump sounds during
pump out
Drain pump starts and
stops several times during
each drain
Rattling dishes when the
spray arm rotates
Rattling silverware against
door during wash
This problem is likely
caused by a low quality
phosphate-free dishwasher
detergent
What To Do
Do not interrupt the cycle by opening the door during the
wash cycle.
Raise the water heater temperature to between 120°F
and 150°F.
These are all normal. No action is required.
Make sure dishes are properly loaded. See the Loading
section.
Tall utensils may be placed in the upper rack to avoid
bumping against inner door during wash cycle.
To remove the white film, run your dishes through a
dishwasher cycle with citric acid. Use a WD35X151
citric acid kit found online. Otherwise, use
Dishwasher Cleaner found at your local grocery store.
Pour the citric acid in the detergent cup and close the
cover. Place the filmed but otherwise clean glassware and
dishware in the dishwasher. Leave silverware and other
metal items out of the dishwasher. Turn the dishwasher on
and let it run through a complete cycle without detergent.
The glassware, dishware, and dishwasher should come out
film free. Alternatively, a vinegar rinse may be used. Pour 1
cup of vinegar into dishwasher just after the detergent cup
opens and let the dishwasher complete its cycle.
This may be repeated several times a year as needed.
The use of a rinse agent such as
Rinse Aid may help minimize a repeat build up of film.
Also, the use of a highly rated detergent such as
Quantum Automatic Dishwashing Detergent
®
prevent film build-up.
3
Add additional items.
4
Press Start and close the door within 4 seconds to
resume the cycle.
Finish
®
Finish Jet-Dry
® ®
Finish
®
will help
49-55124-4