Orbegozo HPE 8075 Manual De Instrucciones página 19

HPE 8075
In case of no time pre-set, press the menu button or "function menu" button, the indicator will light up,
denoting the start of the cooking.
Pressure holding process begins when pressure inside is high enough:
a. If you press any menu button on the panel, the display will show "P000".
b. If you press the "function menu button", the display will show "P000". (00 denotes pressure holding time;
for example, if you se 15 minutes, the display will show 0P15), and the pressure holding time decreases
in 1 minute internal.
When pressurizing is over, it will deliver three rings, the working indicator will go out and the display
shows "0000", reminding the end of cooking and start of keep warm process. The "keep warm" indicator
flashes if pressure inside is high; the indicator just remains on if the pressure is low.
Press "keep warm/cancel" button to cancel parameter setting or current working status.
Press once more time to cancel the "keep warm" status and the indicator goes out.
8. "Keep warm" indicator flickers to indicate the food is ready. The display shows "bb". Press "keep
warm/cancel" to cancel and you can take food now.
- Set the pressure limiting air relief valve to "exhaust" and discharge the air until the float controlled valve
drops.
 When the fluid food such as congee is cooked, the pressure discharging valve cannot be taken up
immediately after the "keep "arm" indicator begins to flash. What until the floating valve is no longer
floating or the food may puff off with the steam. A wet towel on the lid can speed up the cooling.
 It is recommended that the steam is discharged when the indicator is on without flashing. The pressure is
much lower at this time.
 Unplug the power cable.
 Hold and turn the handle clockwise until the lid comes to the clamping position and take up the lid.
6. CLEANING
1. Unplug the power cable prior to cleaning.
2. Brush the bottom of the cooker with a mop. Never steep the cooker into water or spray water on
it.
3. Take off and clean the water collector and wash it with a wet towel.
4. Clean the inner side of the cooker, including the sealant washer, pressure discharging valve, anti-
blocking case, steam relief pipe, floating valve with water and clean it with a mop.
5. Use a sponge or nonmetal soft brush to clean the inner take and clean it with a mop.
6. Clean the seat of pressure limiting air relief valve and water drain hole with a small brush, so that
water can be freely discharged.
No. Symptom
1 Difficult to
cover
2 Difficult to
uncover
3 Steam
Diagnosis
The sealant washer is not well placed.
Floating valve stuck on the bar.
The floating valve is not down in place.
Sealant Washer is not in.
Solution
Place the seal washer in a proper
position.
Push the bar slightly
Slightly press the valve with chopsticks.
Put in the sealant washer
19