Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the risk of electric shock, insure electricity
1.
has been turned off at the circuit breaker or fuse box
before beginning.
All wiring must be in accordance with the National
2.
Electrical Code ANSI/NFPA 70-1999 and local electrical
codes. Electrical installation should be performed by a
qualified licensed electrician.
WARNING: To reduce the risk of fire or electric shock, do
3.
not use this fan with any solid-state speed control device.
CAUTION: To reduce the risk of personal injury, use only
4.
the screws provided with the outlet box.
The outlet box and support structure must be securely
5.
mounted and capable of reliably supporting 35 lbs. (15.9
kg). Use only UL Listed outlet boxes marked "Acceptable
for Fan Support of 35 lbs. (15.9 kg) or less."
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT TO OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT OF 35LBS. (15.9 KG) OR LESS", AND USE SCREWS
PROVIDED WITH THE OUTLET BOX.
The fan must be mounted with a minimum of 7 feet
6.
clearance from the trailing edge of the blades to the floor.
Do not operate reversing switch while fan blades are in
7.
motion. Fan must be turned off and blades stopped before
READ AND SAVE THESE INSTRUCTIONS
reversing blade direction.
Avoid placing objects in path of the blades.
8.
To avoid personal injury or damage to the fan and other items,
9.
be cautious when working around or cleaning the fan.
Do not use water or detergents when cleaning the fan or fan
10.
blades. A dry dust cloth or lightly dampened cloth will be
suitable for most cleaning.
After making electrical connections, spliced conductors
11.
should be turned upward and pushed carefully up into
outlet box. The wires should be spread apart with the
grounded
conductor
conductor on one side of the outlet box.
Electrical diagrams are for reference only. Light kits that are
12.
not packed with the fan must be UL listed and marked suitable
for use with the model fan you are installing. Switches must be
UL General Use Switches. Refer to the instructions packaged
with the light kits and switches for proper assembly.
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS ("FLANGES") DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.
PLEASE REMOVE RUBBER MOTOR STOPS ON THE BOTTOM OF THE
FAN BEFORE INSTALLING BLADES OR TESTING THE MOTOR.
and
the
equipment-grounding
Safety Rules 1.
Publicidad
