Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
16. Join the connectors (16.1) for the LED light from the fan
housing (A) to the grille (B). The grille (B) must be connected
before turning on power to the fan.
17. Attach the grille (B) by pinching the mounting springs and
inserting them into the narrow rectangular slots in the fan
housing (A).
Turn on power source. Test the unit.
CARE AND CLEANING
CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or
removing the fuse from the fuse box.
See safety information before proceeding. Routine maintenance should be done at least once a year.
• Never use solvents, thinner or harsh chemicals for cleaning the fan.
• Do not allow water to enter the motor.
• Do not immerse metal parts in water.
• Do not immerse resin parts in water more than 140°F.
WARNING: RISK OF ELECTRIC SHOCK! Ensure the
electricity to the wires you are working on is shut off. Either
remove the fuse or turn off the circuit breaker before removing
the existing bath fan or installing the new one.
16
17
Housing
slots
11
A
16. 1
B
A
Mounting
springs
B
Publicidad
