Parkside PKIK 4.3 B3 Guia Rápido página 46

PARKSIDE PKIK 4.3 B3
6.5.13 Transferring recordings to a computer
You can use the USB cable [F] supplied to connect the borescope to a
computer (system requirements: 1 free USB port) and transfer your recordings
to it. Proceed as follows:
CAUTION! Loss of data
Be careful when renaming any folders and files. Do NOT try to
change the folder or file names stored on the device from the
computer or you may not be able to read any files contained
here on your borescope.
Once you have copied your files or folders to the computer, you
can rename or edit them on the computer.
Unplug the mass storage device via the operating system's safely
remove hardware feature before disconnecting the USB cable [F]
from the borescope and the computer.
The manufacturer accepts no liability for any loss of data!
•
Plug the USB cable [F] into the USB-C port [9] and into a free USB port
on your powered-on computer.
•
If the borescope was switched off, it will switch on automatically. A USB
cable symbol appears on the display [1].
•
The computer will now set up a removable disk that can be used to
access your recordings.
•
Now you can transfer the recordings to your computer.
•
After you have finished transferring the recordings to your computer,
safely unplug the removable storage media using the corresponding
function of your operating system.
•
Unplug the USB cable [F] from the borescope and the computer.
•
The borescope switches automatically off after a few seconds.
44 - English