Publicidad
Idiomas disponibles
Idiomas disponibles
Illustration # 1
1.
2.
Shelves installation
This appliance is equipped with wooden shelves. You can move the shelves out and in smoothly.
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves
approximately 1/3 out of the rail compartment.
To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwdriver
to press down the right plastic notch as shown in Figure A and at the same time lift the left plastic
notch as shown in Figure B. Then proceed to pull out the shelf slowly. Contact our service department
if assistance is needed.
Defrosting:
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the
appliance's refrigerated surfaces are defrosted automatically. The defrost water is channeled into a
condensates evaporation tray which is located in the back of the appliance near the compressor. The
heat produced by the compressor then evaporates the condensates collected in the tray.
Gasket
Phillips Head Screw
Figure A
3.
Phillips Head Screw Driver
4.
Handle
Figure B
25
Illustration # 2
Publicidad
