Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Attaching the quick connector
to the receiving block
□
Push the quick connector (J) rmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
□
If it is necessary to remove the quick connector
(J), squeeze the tabs on the hose and then pull
down to disconnect.
□
After connecting the hose, install the weights (K)
at the lowest point of the hose.
K
8
Installing the soap dispenser
□
Insert the body assembly (M) through the
selected hole in the sink. Secure the body
assembly to the sink with the nut (N).
□
From under the sink, screw the bottle (O) onto
the body assembly (M) shank. Insert the pump
(L) down into the body assembly (M).
1
J
8
L
M
N
O
Publicidad
