Trevi GO 2550 4K Manual De Usuario página 14

SUGGESTED USES OF MOUNTS
Attach the camera to helmets, parts and equipment using the appropriate accessories.
INSTRUCTIONS FOR USE
1. Insert micro SD card into the port:
Make sure to insert the card with the top side facing the screen. The bottom of the card with the connectors
should be directed towards the front of the camera.
Note: Please choose branded Micro SD card and format it on your computer before use. Neutral cards are not
guaranteed to work normally.
2. Installing and removing batteries
• Slide the cover and open the battery compartment.
• Insert the battery in the correct position so that the battery +/- battery terminals fit into the connectors on the
camera. After inserting the battery, close the cover.
• The battery indicator on the screen shows the battery charge level.
• To replace the battery, open the battery compartment and remove the battery by pulling its strap. Insert a new
battery and close the cover.
3. Charging
• The GO 2550 4K battery can be charged by connecting the device to any USB port on your computer via a
USB cable.
• The camera can also be charged in a car using a 5V USB type-C plug charger (not supplied).
• The camera can be used for recording even while charging.
4. Turn ON/OFF
• Press and hold the MODE button for 3/5 seconds to turn the camera on or off.
• The screen will turn off automatically, according to the MENU settings. To turn the screen back on, press the
OK key.
+
=
+
=
+
+
+ +
14
Trevi
GO 2550 4K
=
=
ENG