Publicidad
Idiomas disponibles
Idiomas disponibles
Accidental restart preventive
function
If you install the battery cartridge while pulling the
switch trigger or locking the switch trigger, the tool does
not start. To start the tool, release the switch trigger, and
then pull the switch trigger.
Electronic function
The tool is equipped with the following electronic func-
tion for easy operation.
Soft start
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
Basic operations
CAUTION:
Do not mix flammable materials or
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
Do not mix high viscosity material
in the high speed mode. You may lose the control of
the tool and cause an injury.
CAUTION:
Do not rotate the mixing blade
outside the stirring vessel.
CAUTION:
If you hear an abnormal noise
during use, turn off the switch and stop using the
tool.
NOTICE:
When you mix the material while the
mixing blade floating out of the material, be care-
ful not to splash the material.
NOTICE:
Do not use the tool for any purpose
other than stirring mortar, concrete, etc.
1.
Select high speed mode or low speed mode
according to the material to be mixed.
2.
Hold the tool firmly with both hands. Place the mix-
ing blade under material fully. Check that the material is
not solidified and the safety of the work site, then turn
on the tool.
3.
Move the mixing blade up and down during the
mixing operation so that whole part of material can be
mixed.
4.
When finishing mixing, turn off the tool. Make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.
Applied operations
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Replacing battery cover
Optional accessory
Install one of the battery covers to fit the size of your
battery cartridge.
3
Fig.13
► 1. Battery cover S 2. Battery cover L 3. Button
1.
Open the standard equipped battery cover while
pressing the button on the battery cover.
2.
Loosen the screw securing the standard equipped
battery cover. Then remove the screw, sleeve and the
battery cover.
Fig.14
► 1. Screw 2. Sleeve 3. Battery cover (standard
equipped)
NOTE: The sleeve may remain in the mounting holes.
In that case, pull it out using a screw or the like.
9 ENGLISH
1
3
3
2
2
1
Publicidad
