BOHELL TALI12 Manual De Instrucciones página 19

INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Ensure that the voltage indicated on the rating
label matches the mains voltage before plug-
ging in the appliance.
INSERT A DRILL BIT:
- To open the drill's chuck, whilst completely
switched off, take firm hold of the back part of
the chuck and turn the front part of the chuck
counter clockwise.
- Insert the drill bit, screwdriver bit, or other tool/
accessory required for the task, into the chuck.
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
Take firm hold of the back part of the chuck and
turn the front part of the chuck clockwise until it
is firmly closed.
- In order to remove accessories from the chuck,
follow the same steps as indicated previously
but in reverse order..
SELECT THE ROTATION DIRECTION:
- The appliance has a selector (F) to change the
rotation's direction.
- Do not change it when the motor is running.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance is regulated accord-
ing to the pressure exerted on the switch (G).
- CAUTION: if the appliance continuously work
at low speed, the life of the appliance could be
harmed seriously.
SCREWING
- To screw, place the torque adjustment ring from
1 to 17 (according to the finishing you want to
obtain, 1 for less force applied and 17 for max
force applied).
- Insert the matching bit to the screw, so you don't
harm neither the screw or the bit.
DRILLING
- Turn the torque adjustment ring to the drilling
position ( )
USE:
- Select the appliance function desired, and the
rotation desired, according to previous points.
- Turn the appliance on by pressuring the switch.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by releasing the on/off
switch.
- Remove the battery from the appliance if you
are not intending to use the appliance during an
extended period.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- These supplies are available in specialist shops.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.