Samsung DW80B60 Serie Manual De Instalación página 13

STEP 3 Check water supply requirements and cautions
• The hot water supply line pressure must be between 20 ~ 120 psi (140 ~ 830 kPa).
• Adjust the water heater to deliver water between 120 °F (49 °C) ~ 149 °F (65 °C).
- The dishwasher must be connected to a hot water supply between 120 °F
(49 °C) ~ 149 °F (65 °C). This temperature range provides the best washing result
and shortest cycle time. Temperature should not exceed 149 °F (65 °C) to prevent
damage to dishes.
- Ensure that the water supply valve is turned off before connecting the hot water
supply line to the dishwasher.
- Seal the hot water supply line connections using teflon tape or sealing compound to
stop any water leakage.
- The drain hose connected to the dishwasher must be run through the hole in the
side wall so it can be connected to the drain outlet of the sink. When you install the
dishwasher, ensure there is nothing on the drain hose and be careful not to damage
it during the installation process.
Figure 2
Power cable Power cable
Hot Water Hot Water
Supply Line Supply Line
Inlet valve Inlet valve
DW7000B_DW80B7070_AA_DD68-00242A-01_EN.indd 13 DW7000B_DW80B7070_AA_DD68-00242A-01_EN.indd 13
4¼-6¼ in. 4¼-6¼ in.
(110-160 mm) (110-160 mm)
Dishwasher bottom Dishwasher bottom
English 13
2021-12-21 2021-12-21 3:35:42 3:35:42