Publicidad
Idiomas disponibles
Idiomas disponibles
REVERSING THE DOOR SWING
REPLACE THE DOOR HINGE
5
AND THE DOOR HINGE COVER
ON THE OPPOSITE SIDE
• Rotate the door hinge and
replace it on the opposite
side with its screws.
• Rotate the door hinge
cover and replace it on
the opposite side with its
screws.
REMOVE THE TERMINAL
6
HOLDER AND DISCONNECT THE
PIN CONNECTOR FROM WASHER
• Using your fingers,
pry the terminal holder
from the washer face.
• Disconnect the pin
connector.
REMOVE LOCK ASSEMBLY AND
7
INSTALL ON OPPOSITE SIDE OF
WASHER
• Remove the 2 screws
from the lock cover
plate and remove it
from the washer face.
• Insert the provided lock bar
into the lock mechanism in
the washer face. Remove
the lock assembly by
removing its two screws,
using the lock bar to lift it
up to unhook, tilting and
pulling it out of the washer
face. Disconnect its pin
connector by unsnapping
its locks.
*After the door reversal is finished, run the washer
through a complete cycle to verify proper operation.
24
Installation Instructions
Hinge
Cover
Hinge
Terminal
Holder
Pin
Connector
Lock
Cover
Plate
Hook Window
Hook
Insert
Lock Bar
Remove
Assembly
Pin Connector
(OPTIONAL ON SOME MODELS ONLY)
• Do NOT rotate lock
assembly. Move it to
the opposite side of the
washer and connect the pin
connector making sure it is
fully snap locked together.
Tilt and insert the lock
assembly into the washer
face, lift it up and latch
its hook into its window.
Replace its screws. Remove the lock bar from the
assembly and retain for future use.
• Remove the
lock switch
Press the cover button out,
cover button
from front-to-back,
from the back
of the lock
Rotate the cover button,
cover plate
from top-to-bottom, and
and replace it
press it into the back of
in the opposite
the lower hole
hole in the lock
cover plate.
NOTE: The cover button
must be reinstalled
into the lower hole in
the lock cover plate as
shown.
• Install the lock cover plate
over the lock assembly,
making sure that the lock
switch operates freely.
Replace its screws.
RECONNECT PIN CONNECTOR
8
FROM WASHER AND REPLACE
TERMINAL HOLDER
• Reconnect the pin
connector and press the
terminal holder back into
the washer face on the
opposite side.
REPLACE THE DOOR ASSEMBLY
9
• Lift the door assembly
into place and secure it
onto washer face with its
6 screws.
• Close the washer door.
NOTE: Make sure the
door opens and closes
correctly. If not, repeat
all steps making sure all
parts and screws are securely seated.
• Connect power cord and turn on the breaker.*
Hook
Window
Hook
Remove
lock bar
Replace
Assembly
Pin Connector
Lock Cover Plate
to remove it
Lock Cover Plate
Lock
Switch
Cover
button
in lower
hole
Pin Connector
Terminal Holder
Replace this
screw first
Replace 6
screws into
the hinge and
secure into the
washer face
49-3000364 Rev 1
Front
Side
View
Publicidad
