Vaporfi vBit Manual De Usuario página 6

REBUILDING YOUR ATOMIZER
1. Take the bottom piece of your RDA (also known as the deck) and unscrew the post
screws counterclockwise until all post holes are exposed.
2. Insert your first coil lead into the negative post of the atomizer deck.
3. Tighten down the screw on the negative post with your screwdriver and insert the other
lead into the positive post.
4. If desired you can repeat steps 2-3 on the opposite side of the RDA deck for maximum
vapor production (keep in mind, this will also provide user with a hotter denser vape.)
5. Clip off all excess wire from the negative and positive posts.
6. Screw your atomizer onto your device and pulse-fire the coils until evenly red from the
inside out.
7. Add your wick by threading a piece of cotton through each coil. The piece of cotton
should be snug but able to slide easily through the coil.