Publicidad
MIRROR ASSEMBLY
Before proceeding with the following steps, prepare a clean, flat work surface.
1. Using a Phillips Head Screwdriver, remove the flat head screws holding the back panel in place, setting them aside in a safe place.
NOTE: The back panel is heavy. Attaching a couple of pieces of masking tape can lift the panel enough to ease removal.
2. Insert the Adjustable Down Rod [220-1261-XX] through the opening in the top of the mirror and internal bracket.
1
2
© 2024 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
12
Part no. CB-209-1455 01/25/2024
Sculpt Hanging Mirror Installation
Publicidad
