Publicidad
CEILING MOUNT
Whether the ceiling is lofted or flat, the Ceiling Adapter [220-1264-XX] will need to be set to match the ceiling pitch.
1. Thread a Down Rod Connector [219-1747] into the bottom of the Ceiling Adapter. The pivoting portion of the Ceiling Adapter should
be loose.
2. The Ceiling Adapter will adjust to match the angle of the ceiling. Tighten the Down Rod Connector until the pivoting portion is no
longer loose. If needed, use the Allen Key [203-1698] provided. The set screw will be tightened at a later step to lock the Ceiling
Adapter's position.
NOTE: For reference, the following steps show the Ceiling Adapter in a vertical, flat ceiling orientation.
1
© 2024 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
2
0°
45°
8
Part no. CB-209-1455 01/25/2024
Sculpt Hanging Mirror Installation
Publicidad
