Publicidad
MOUNTING THE MIRROR
3. With a second person lifting the mirror, remove the M5 screw and nut previously inserted through the Down Rod.
4. Reinsert the M5 screw with an included split washer [203-1696] through the mirror bracket and Down Rod. Attach the remaining
split washer and hex nut on the other side of the Mirror Bracket. If needed, adjust the height before fully tightening the hardware.
3
4
© 2024 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
15
Part no. CB-209-1455 01/25/2024
Sculpt Hanging Mirror Installation
Publicidad
