DESCRIPTION OF APPLIANCE
The following terminology will be used repeated on the following pages.
A.
Pitcher lid
B.
Pitcher
C.
Boiler
D.
Disk filter
E.
Gasket
F.
Support base
G.
Power cable
H.
ON/OFF switch
I.
Pilot light
J.
Safety valve
K.
Funnel filter
L.
6 cup adapter
M.
Tube
INSTALLATION
•
Place the appliance on a bench away from water taps and sinks.
•
Check that the voltage of the mains power supply corresponds to the value indicated on the
appliance's rating plate. Only connect the appliance to a power outlet with a minimum rating of
6A that is properly earthed. The manufacturer declines all liability for any accidents caused if the
system is not correctly earthed.
HOW TO PREPARE THE COFFEE
1)
Check that the coffee maker is cold, and then unscrew it by holding the boiler with one hand and turning
the pitcher anticlockwise with the other.
2)
Remove the funnel and to prepare 6 cups of coffee, fill the boiler with fresh water until reaching the
safety valve (visible inside the boiler), without exceeding it.
TIP: Use fresh and soft water. Salty or hard water will weaken the flavor.
IMPORTANT: Do not use the coffee maker without water in the boiler or alternatively using hot water for faster
operation.
3)
Insert the funnel filter in the boiler. To prepare six cups of coffee, also insert the 6 cup adapter in the
funnel filter.
4)
Fill the funnel filter with ground coffee, without pressing it. Fill it a little at a time to prevent spilling the
ground coffee.
5)
Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter.
23