Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 Turning the radio receiver on/off
To turn on the device, slide the ON/OFF switch on the back of the device to ON.
To turn the device off, slide the switch to OFF.
6.3 How to pair the Bluetooth radio receiver with a mobile device via Bluetooth
To pair the radio receiver with your phone or another mobile device, follow the instructions below.
Set the ON/OFF switch to ON.
1.
Press the MODE button — the blue LED signaling the BT (Bluetooth) mode will start flashing quickly.
2.
3.
Enable Bluetooth in your mobile device and select the radio receiver on the list of available devices
(VC Radio).
4.
Connect / pair the devices. The blue BT (Bluetooth) LED will stop flashing quickly. Instead, it will light
steadily, if the devices are paired correctly.
6.4 Operation in BT (Bluetooth) mode
If the radio receiver is connected to a mobile device using Bluetooth, the blue BT LED will continuously light
blue after turning on. This means you can transmit the sound from your phone or another device with a
Bluetooth transmitter to the radio with Bluetooth speaker.
6.5 Operation mode change (Bluetooth/AUX/FM/USB)
To change the operation mode, press the MODE button — select the desired operation mode: Bluetooth/
AUX or FM/USB. The current operation mode will be signaled by the respective LED, as labelled on the radio
front panel: BT/AUX or FM/USB. If the Bluetooth mode is enabled, the blue signaling LED will start pulsating
(approx. every 2 s). The radio is in connect mode and is will be able to pair to a Bluetooth enabled device.
After the pairing is complete the blue LED light will be light on continuously. To play the music from an
external source using the 3.5 mm audio jack cable, connect on end of the cable to the radio and the other
to the external device. The LED light will start to blink red in the BT/AUX setting. The device you intend to
play audio from must be equipped with an output audio jack 3.5 mm socket. To listen to the radio, unclip
the antenna on the back of the housing and extend/unfold it. Now change the mode to FM/USB and set
the required radio frequency using the radio station selection knob. The radio also supports playing music
from USB drives. To do this plug in the USB drive and change the mode to FM/USB, the LED will turn to a
blue continuous light and the music files on the USB drive will play. You can control the control panel on the
back of the radio to pause/play and skip music tracks.
6.6 Volume adjustment
To set the required volume, use the VOL volume adjustment knob (rotate left (-) to reduce the volume, rotate
right (+) to increase it).
Caution! If the radio receiver is connected to another audio playing device, you may also adjust the volume
on the devices paired via Bluetooth or connected using the audio cable.
7 Cleaning and maintenance
Proper and regular cleaning will ensure safe operation and extend the life span of the appliance.
Wipe the housing with a soft, dry cloth.
Caution!
Do not clean the appliance with any strong chemicals, alkali, abrasive or disinfecting agents, as they
may damage the surface of the appliance.
Do not use metal, sharp or rough cleaning accessories, as they may damage the surface of the appli-
ance!
Do not immerse the appliance in water or other liquids!
Before you use the appliance again, make sure it is completely dry.
11
Publicidad
