Whirlpool AKP 745 WH Guía Rápida página 4

CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before carrying out any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance.
Wear protective gloves.
The oven must be disconnected from the mains before carrying out any kind of maintenance work.
EXTERIOR SURFACES
Clean surfaces with a damp microfibre cloth. If they are very dirty,
add a few drops of pH-neutral detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of these products
inadvertently comes into contact with the surfaces of the appliance,
clean immediately with a damp microfibre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then clean it, preferably
while it is still warm, to remove any deposits or stains caused by
food residues. To dry any condensation that has formed as a result
of cooking foods with a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge.
Clean the glass in the door with a suitable liquid detergent.
The oven door can be removed to facilitate cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after use, handling
them with oven gloves if they are still hot. Food residues can be
removed using a washing-up brush or a sponge.
TROUBLESHOOTING
What to do if...
The oven is not working.
* Available only on certain models
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website
• Using QR Code
• Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification
plate.
Possible reasons
Power cut.
Disconnection from the mains.
docs . whirlpool . eu
contact our After-sales Service
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew the cover from
the light, replace the bulb and screw the cover back on the light.
Reconnect the oven to the power supply.
Please note: Only use 20-40 W/230 V type G9, T300 °C halogen bulbs.
The bulb used in the product is specifically designed for domestic
appliances and is not suitable for general room lighting within the home
(EC Regulation 244/2009). Light bulbs are available from our After-sales
Service. Do not handle bulbs with your bare hands as your fingerprints
could damage them. Do not use the oven until the light cover has been
refitted.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lift the catches, pushing them
forwards until they are in the unlock position (1). Close the door as
much as you can. Take a firm hold of the door with both hands – do not
hold it by the handle. Simply remove the door by continuing to close
it while pulling it upwards at the same time until it is released from its
seating (2). Put the door to one side, resting it on a soft surface.
a
b
1
Refit the door by moving it towards the oven, aligning the hooks of the
hinges with their seating and securing the upper part onto its seating.
Lower the door and then open it fully. Lower the catches into their
original position (3): Make sure that you lower them down completely.
Apply gentle pressure to check that the catches are in the correct
position.
a
b
3
Try closing the door and check to make sure that it lines up with the
control panel. If it does not, repeat the steps above: The door could
become damaged if it does not work properly.
Solutions
Check for the presence of mains electrical power and whether
the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
(See phone number in the warranty booklet). When
~15°
b
a
2
Model: xxxXXXXxx XXXXXXXXXXXXXX