Schrack BX02P192007 Serie Manual De Usuario página 36

Idiomas disponibles

ACK VERSION

The sequence of operations required to convert the BATTERY BOX into the rack version is described

below.

WARNING: for your safety and that of your product, follow the information set out below exactly.

BEFORE CARRYING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE

THAT THE BATTERY BOX IS NOT CONNECTED TO THE ELECTRICITY MAINS, TO

1 - First remove the 4 feet at the base of the

BATTERY BOX. Put the BATTERY BOX

into a horizontal position taking the utmost

care and with a small slotted screwdriver

carefully lift the pin at the centre of the foot.

Once it has been lifted, remove the foot

from the base. Repeat the same operations

for the remaining feet. The exact sequence

to follow is shown at the side:

2 - Once all the feet have been removed, the mask must then be rotated.

Insert the keys provided in the release slots located at the sides of the

mask and exert enough gentle pressure to release it from the BATTERY

BOX, as shown in the figure at the side.

3 - (only for the version with battery charger): The mask is connected to the BATTERY BOX by a

specific cable. The mask must therefore be removed with the utmost care and avoiding violent pulls

or other sharp movements so as to avoid any damage to the LED panel and/or to the actual

BATTERY BOX. DO NOT UNDER ANY CIRCUMSTANCES TRY TO SEPARATE THE MASK

FROM THE BATTERY BOX.

4 - Rotate the mask 90° anticlockwise, carefully insert in the housing and exert gentle pressure near the

release slots until a slight click is heard with the mask remaining in position.

5 - Rotate the BATTERY BOX 90° clockwise taking the utmost care.

6 - At this point, with the BATTERY BOX in a horizontal position, fasten

the handles to the sides with the screws as shown in the figure at the side.

NOTE: The BATTERY BOX is compatible for mounting in standard rack cabinets of 600mm x 800mm or

more (in width). Support brackets (guides with L-shaped support) must be used in the rack

installation due to the weight of the batteries. Installation in the lower part of the rack cabinet is

recommended for the same reason.

THE UPS OR TO ANY OTHER BATTERY BOXES

NSTALLATION