Publicidad
Idiomas disponibles
Idiomas disponibles
at the same time for 3 seconds.
3. Repeatedly press
FAN MODE
The exhaust hose is not required during FAN MODE operation.
1. Repeatedly press
2. Repeatedly press
The temperature cannot be adjusted in this mode.
DRY / DEHUMIDIFY MODE
The exhaust hose is not required during DRY MODE operation.
Repeatedly press
The fan speed or temperature cannot be set. The fan will automatically operate
at LOW speed.
NOTE: Keep windows and doors closed for the best dehumidifying effect.
LED DISPLAY
The LED display shows the set temperature in COOL mode. While in DRY or FAN
mode, it shows the ambient room temperature.
OPERATING FROM THE REMOTE CONTROL
Battery installation
1. Slide the battery cover off the remote control.
2. Insert the supplied batteries, paying attention to match up the (+) and (-)
ends of the batteries with the symbols inside the battery compartment.
3. Slide the battery cover back into place.
TIPS FOR USING REMOTE CONTROL
•
Point the remote control at the receiver on the appliance. The remote control
must be no more than 8 meters away from the appliance (without obstacle
between the remote and receiver).
•
The appliance will beep when remote signal is received.
•
Curtains, other materials and direct sunlight can interfere with the infrared
signal receiver.
•
Remove batteries if the remote will not be used for more than 2 months.
188
on the remote control to choose adjust the fan speed.
until the FAN indicator light illuminates.
on the remote control to choose the fan speed.
until the DRY indicator light illuminates.
Publicidad
