Publicidad
Idiomas disponibles
Idiomas disponibles
• Battery management
1
98%
Menu setup
Battery mgmt.
Informations
Affiliation
Display setup
Language
TX Power
98%
Battery capacity
950
1000
1050
1100
1150
1200
Battery capacity:
Select the capacities of the rechargeable NiMh
batteries applied in the transmitter.
The values are between 800 and 1200 mAh
and to refer at the single rechargeable NiMh
battery.
The standard rechargeable NiMh battery
applied is 1100 mAh.
Note: use only rechargeable batteries
type NiMh.
The standard rechargeable battery applied is type
NiMh at 1,2 V - 1100 mAh.
Note: use only rechargeable batteries type NiMh.
98%
FW: x.x.x
BATTERY
CHARGE RUM
Voltage: 3.87 V
Current: 0.088 A
0.0.0.0.0.0
2
98%
Battery management
Rechargeable
Battery pack level
Battery Capacity
Voltage: shows the voltage of the batteries. The range of this
value is included from 3.6 V (discharged batteries) to 4.10 V
(charged batteries).
Current: if the value has positive sign (+) it means that the battery
charger is connected and the value shown is the current supplied
to the batteries for charging. if the value has negative sign (-) it
means that the battery charger is disconnected and the value
shown is the instantaneous current absorbed by the transmitter to
operate.
Charge: shows the charge of batteries in mAh.
Level: shows the charge of batteries in percentage.
Status: Charging = battery charger connected.
Recharge the batteries
During charging, the following indications may shown on the display:
•
Charge no needed - The battery voltage exceeds the 4.10V threshold,
therefore the charging circuit is not activated (the battery level is set to 95%).
•
Battery charge run - The battery voltage is lower than the 4.10V threshold,
therefore the charging circuit is activated.
•
Battery charge ending - The battery voltage exceeds the 4.40V threshold,
therefore the charging circuit is disabled and the charge percentage increases
up to 100%
•
Charge complete - The batteries are charged and the percentage displayed is
100%
•
Charge suspended - The charging procedure was not successful.
•
Battery error - The batteries were removed during charging and the voltage
exceeded the 5.00V threshold (no other data is shonw in the display).
Voltage: showns the voltage of the batteries during charging. The value is
between 3.6 V (discharged batteries) and 4.20 V (charged batteries).
Current: showns the current supplied to the batteries for charging.
Rechargeable function settings
NiMh Rechargeable batteries
NON Rechargeable batteries
Warning: The transmitter is supplied
with NiMh rechargeable batteries. If
you
replace
rechargeable batteries, set the " NON-
rechargeable batteries" function.
Battery management
Volatge
Current
Charge
Level
USB Conn.
Status
Discharging = battery charger disconnected.
(see attachment "A")
Please note that the old battery cannot be
disposed of with non-differentiated urban
waste but must be collected separately in
accordance with the regulations set down
by the local authorities.
10
these
with
NON-
98%
4.02V
- 0,293A
957 mAh
96%
Absent
Discharging
Publicidad
