Zodiac RE/U Manual De Instalación Y De Uso página 23

3.1 I Presentation of the regulation system
The regulation thermostat with its digital display is delivered pre-assembled on the heater, electrically
connected thereto and factory pre-set for pool heating .
Principle: A regulation sensor, placed at the pool water inlet to the heater, measures the pool temperature
(when filtration is active), and compares this value to the setpoint value. If the pool water falls below or is
below the setpoint value, the regulator authorises heating.
Press and release
• Read or modify the temperature setpoints
• Confirm
Back
Down
Up
Description
Outlet 1
Outlet 2
Alarm
On/Off
Measurement
unit
3.2 I User functions
3.2.1 Switching the appliance on and off
• Press the
The screen shows the measured water temperature.
• Press the
The screen shows the
3.2.2 Locking/unlocking the keypad
• Press the
The screen shows the "Loc" message to indicate that the keypad is locked.
• Press any key for 1 second to unlock the keypad.
The screen shows the "UnL" message to indicate that the keypad is unlocked.
Information: automatic locking of the keypad
• If no movement is detected on the keypad for more than 30 seconds, the screen shows the
"Loc" message and the keypad is automatically locked.
9
❸ Use
On
Output 1
heating
Output 2
heating
Alarm enabled
Appliance
switched off
Temperature
display
key for 2 seconds to switch the appliance on.
key for 2 seconds to switch the appliance off.
indicator.
and keys for 3 seconds to lock the keypad.
Press and hold
Additional features
On-Off
+
Off Flashing
• Time delay (before activation) output 1.
/
• Change temperature setpoint.
• Time delay (before activation) output 2.
/
• Change temperature setpoint.
/
Appliance
Appliance switching off
switched on
/
: Lock the keypad
/
/