OPERATING & GROUNDING
INSTRUCTIONS
1. Heaters are provided with flexible cord with a
grounded 2 blade plug (as shown at A in
Figure 3) and built-in ON/OFF switch. This
heater is for use at 120 V AC only.
2. An adapter as shown at C in Figure 3 is
available for connecting three-blade
grounding-type plugs to two-slot receptacles.
The green grounding plug extending from the
adapter must be connected to a permanent
ground such as a properly grounded outlet
box. The adapter should not be used if a
three-slot grounded receptacle is available.
3. Occasionally a new heater will emit a slight
"new smell" odor during initial use. This smell
should dissipate within the first hour of use.
4. Always unplug heater when not in use. When
heaters are not to be used for an extended
period of time, cord should be coiled and tied
to prevent damage and heater should be
stored in a safe location.
MAINTENANCE
INSTRUCTIONS
1. If heater fails to operate or if heater or power
cord becomes damaged, unplug and
discontinue use. DO NOT attempt to repair
the heater. There are no user-serviceable
parts inside.
2. Heater may be cleaned using a damp cloth or
sponge and a mild detergent.
Never submerge or soak heater in water.
Always turn heater off and unplug before
cleaning. Heaters may be repainted if desired.
Use only high temperature water based
acrylic paints.