Carbest 67041 Manual Del Usuario página 16

APPLIANCE PERFORMANCE
DE
• This appliance is designed to raise the outlet
water temperature by and average of 25 °C
EN
above the source water temperature and can
be adjusted by the gas control knob located
on the top of the appliance.
IT
• In the event that the temperature lift is insuf-
ficient simply run water through the appliance
once returning the heated water to the source
ES
water reservoir then run again through the
appliance until the desired temperature
FR
reached.
NL
SAFETY FEATURE
This appliance is equipped with the following
FI
safety features:
• Over temperature sensor - the appliance will
not allow the burner to remain in operation
DK
once the outlet water temperature reaches 50
°C, the burner will automatically relight once
SE the outlet temperature falls below 50 °C.
• Water flow sensor - water must be flowing
through the system to allow the burner to
ignite. In the case that the water supply is
restricted or ceases e.g. the water regulation
switch is in the „OFF" position, the burner will
be extinguished and will not relight until the
water flow recommences.
• Tilt switch - in the event that the appliance is
moved during operation or is being operated
on an unstable or non-solid surface the appli-
ance will shut down and must be switched off
until a suitable surface is located.
SETTING UP THE APPLIANCE
• Remove all components from the storage bag
and then place the appliance on a solid,stable
surface and straighten out all hoses to guaran-
tee no kinks or twists remain.
CARBEST Portable Gas Water Heater| 67041/67042
• Attach the DC pump &
hose assembly to the appli-
ance by quick connecting
to the water inlet, then to
the electrical connection
marked "pump".
• Attach the gas hose and
regulator to the "gas inlet"
then connect to the pro-
pane gas cylinder, tighten
all connections with a
spanner.
• Turn the gas cylinder on
in an anti-clockwise direc-
tion full turn, then check
connections for leaks with
soapy water (DO NOT
use a flame). If a leak is
detected turn the cylinder
valve off & retighten all
connections then retest. If
no leaks are detected turn
the cylinder valve to the off
position.
• Swing the water outlet pipe
away from it is storage
position to the side of the
appliance. Take the shower
head & hose assembly and
attach to the water outlet.
• Check that the power
switch at the rear of the
appliance is in the "OFF"
position. Connect the 12V
DC lead in to the power
socket marked "DC input"
and then connect cigarette
fitting in to a suitable DC
power source.
16