Publicidad
Idiomas disponibles
Idiomas disponibles
•
Insert the
and
into the slot of
2
3
insert the
into the holes on
1
tighten them.
•
Align
with
(packed separately), press
6
8
into
until
protrudes out open hole in
8
7
•
Align and insert the
10
and
, tighten them with the
6
9
Do not over-tighten. Repeat above process
for the opposite side of fan.
Fan Operation:
3.
Always operate the fan
with the cradle in its upright position. The fan
itself can be titled into various positions
depending on applications, including straight
upward.
Fan Location:
4.
Place the fan in an area in
the room that will provide the most effective
air circulation.
Fan Connection:
5.
120 volt A.C., 60Hz wall outlet. Be sure plug
cause overheating and damage to the plug
or fan.
NOTE:
To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
Turning Fan On:
6.
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
Turning Fan Off:
7.
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
Adjusting Fan Tilt:
8.
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.
CARE and MAINTENANCE
Cleaning:
WARNING:
Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
, then
4
and
2
6
.
8
to the side hole on
.
5
Plug fan directly into
Place fan on stable
To turn the fan off, turn
Loosen the
WARNING:
DO NOT IMMERSE THE FAN
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
before use. Periodic grille cleaning with a
vacuum will prevent dust build up. The motor
is sealed and does not require any interior
maintenance, cleaning or lubrication.
Maintenance:
The Internal motor bearings
are permanently lubricated at the factory and
do not require any additional lubrication.
Repair:
WARNING:
DO NOT OPERATE THE FAN
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage
of the fan. Coil and tie the power cord to avoid
damage during storage.
Free warning label replacement:
warning labels become illegible or are missing,
please call 1-888-899-0146 for
free replacement.
OPTIONAL ACCESSORIES
WARNING:
Since accessories, other than
those offered by D
WALT, have not been
E
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D
WALT recommended accessories should
E
used with this product.
ENGLISH
If
5
Publicidad
