Parkside HG10472 Traducción Del Manual Original página 30

For a water tap with a 26 .5 mm
*
thread (G¾"), first screw
the reducer
1 ] [
connector
2 ] [
the tap connector
tap (see Fig . F) .
Connect the connection hose
*
to the hose connector
connect the hose connector
to the tap connector
(see Fig . G) . Make sure that it
clicks into place .
Connect the other end of the
*
connection hose
hose connector with water
stop . Then connect the hose
4 ] [
connector with water stop
to the connection for supply
hose . Make sure that it clicks
[ 15 ]
into place (see Fig . B) .
Connect the spray nozzle
*
the hose connector with water
stop . Make sure that it clicks
4 ] [
into place . Make sure that the
garden sprayer
(see Fig . I) .
The product is ready for use .
into the tap
and then screw
onto the
2 ] [
[ 13 ]
. Then
[ 3 ]
3 ] [
2 ] [
to the
13 ] [
4 ] [
5 ] [
is closed
5 ] [
˜Dismantling
Carry out the assembly process in
reverse (see chapter "Assembly") .
˜Operation
˜Unrolling the hose
Pull the irrigation hose
*
the hose reel
the desired length (see Fig . H) .
Lower the tension . The irrigation
*
hose
12 ] [
until it is held by the retraction
block .
Turn on the tap . Make sure that
*
the spray nozzle
Open the spray nozzle
*
turning it into clockwise direction
(see Fig . I) .
The irrigation hose
*
to
only be pulled out up to the red
marking .
[ 12 ]
until it reaches
11 ] [
will briefly move back
is closed .
5 ] [
5 ] [
may
12 ] [
out of
by
GB/IE 29