S&P AIRSENS CO2 Manual Del Usuario página 10

ENGLISH
EN
Intelligent sensor available in three different versions: CO2, VOC and RH. De-
signed to create direct demand control ventilation systems. AirSens can be
linked with AC, ECOWATT (EC) fans or VFTM frequency drive.
SECURITY
Installation must be carried out by a qualified professional. Make sure that the
installation complies with mechanical and electrical national regulations. Once
in service, the appliance must comply with corresponding Directives.
Do not use this device in explosive or corrosive atmospheres.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or in-
struction concerning use of the appliance in a safe way
and understand the hazards involved. Children must not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
INSTALLATION
This device must be installed in a dry environment (IP30), over a flat surface
through fixing points (see Fig.4) and will require a type X installation. Height in-
stallation recommended between 1,5 and 1,8m. At the same time, it is impor-
tant to choose an installation location free of conditions that could influence the
measurement such as direct sun light, too close occupant proximity, air flow
coming from windows or doors or ventilation systems.
The front cover is opened a tool pressing both pressure closures located at both
edges of the cover (see Fig.5). For safety reasons, cables must be retained using
the support provided (see Fig.6).
10