Listening To The Radio; Adjust [Settings] Mode Settings - Kenwood KDC-248U Manual De Instrucciones

Item
SWITCH PRE REAR */ SUB-W: Selects whether rear speakers or a subwoofer are connected to the line out terminals on the
rear of the unit (through an external amplifier).
SP SELECT OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance.
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO *: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/

Listening to the radio

1 Press SRC to select "TUNER."
2 Press BAND repeatedly to select a band (FM1/ FM2/ FM3/ AM).
3 Press 4 / ¢ to search for a station.

Adjust [SETTINGS] mode settings

While listening to the radio...
1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
4 Hold to finish the procedure.
Item
Selects the tuning mode for 4 / ¢ buttons.
SEEK MODE
AUTO1 *: Automatically search for a station. ; AUTO2: Search in the order of the stations in the preset
memory. ; MANUAL: Manually search for a station.
AUTO MEMORY YES: Automatically starts memorizing 6 stations with good reception. ; NO *: Cancels (automatic
memorizing is not activated). (Selectable only if [NORM] is selected for [PRESET TYPE].) (page 6)
MONO SET ON: Improve the FM reception (but the stereo effect may be lost). ; OFF *: Cancels (stereo effect resumes).
Using the remote controller (RC-405)
FM+ / AM– : Selects band.
4 / ¢ ( + ) : Selects station.
1 – 6 : Selects preset station.
Selectable setting (Preset: *)
Hold for about 2 seconds to memorize the current station.
Press briefly to recall memorized station.
Selectable setting (Preset: *)
7