Hotpoint Ariston FA3 841 H IX HA Guía Rápida página 43

USING THE APPLIANCE FOR THE FIRST TIME
1.
SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: press
until the icon and the two digits for the hour will
flash on the display.
Use or to set the hour and press
The two digits for the minutes will start flashing. Use
or to set the minutes and press
Please note: When the
following lengthy power outages, you will need to reset the
time.
DAILY USE
1.
SELECT A FUNCTION
To select a function, turn the selection knob to the
symbol for the function you require: The display will
light up and an audible signal will sound.
2.
ACTIVATE A FUNCTION
MANUAL
To start the function you have selected, turn the
thermostat knob to set the temperature you require.
Please note: During cooking you can change the function
by turning the selection knob or adjust the temperature by
turning the thermostat knob.
The function will only start if the thermostat knob is on 0 °C.
You can set the cooking time, cooking end time (only if
you set a cooking time) and a timer.
AUTOMATIC
To start the automatic function you have selected
("Bread" or "Pastry"), keep the thermostat knob at the
position for automatic functions (0/A).
To finish cooking, turn the selection knob to position 0.
Please note: You can set the cooking end time and timer.
RISING
To start the "Rising" function, turn the thermostat knob
to the relevant symbol; if the oven is set to a different
temperature, the function will not start.
Please note: You can set the cooking time, cooking end
to confirm.
to confirm.
icon is flashing, for example
2.
REHEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: This is completely
normal.
Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent
film from the oven and remove any accessories from
inside it.
Heat the oven to 250 ° C for about one hour,
preferably using the "Maxicooking" function. The
oven must be empty during this time.
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the first time.
time (only if you set a cooking time) and a timer.
3.
PREHEATING AND RESIDUAL HEAT
Once the function starts, an audible signal and a
flashing icon on the display indicate that the
preheating phase is active.
When the set temperature has been reached, the icon
becomes fixed and a new audible signal will sound
to indicate that the food can be placed inside and
cooking can proceed.
Please note: Placing food in the oven before the preheating
phase has finished may have an adverse effect on the final
result of cooking.
After cooking and with the function deactivated, the
icon may continue to remain visible on the display
even after the cooling fan has switched off to indicate
that there is residual heat in the compartment.
Please note: The time after which the icon switches off varies
because it depends on a series of factors such as ambient
temperature and function used. In any case, the product
should be considered to be off when the pointer on the
selection knob is at " ".
.
PROGRAMMING COOKING
You will need to select a function before you can start
programming cooking.
DURATION
Keep pressing until the
flashing on the display.
Use or to set the cooking time you require, then
press to confirm.
Activate the function by turning the thermostat knob
EN
icon and "00:00" start
3