Hayward ProChem pH Manual Del Propietário página 10

EN
Default parameters
n Item
1 Language
2 Set Point value
3 Dosing method
4 OFA Time
5 Calibration
6 Circulation pump
7 Flow Input
8 Power ON Delay
9 Flow Delay
To restore the default parameters, follow the steps below:
• Power off the device unit
• Keep and
• The unit will display Init.default
• Press or
• Select Yes and press
6b. Main menu
Press for 3 seconds to run the main menu and then use
Main menu - Press
At the entry of each menu item, the parameter can be directly modifi ed by using
Confi rmation of the current setting and switching to the next item is done by pressing the
The menu has a circular structure: once you arrive at last item, the confi rmation of the parameter set by pressing
determines the return to the fi rst menu item.
Value
EN
7.4 pH
Acid (pH) Low (Redox)
OFF
Full
ON
NO (normally open)
OFF
OFF
pressed and power on the unit
to select Yes or no
to restore the default parameters.
6b1. Calibration
6b2. Setup
6b3. Advanced
for 3 seconds.
ProChem Single | pH · ORP
Only use spare parts supplied by Hayward brands ®
Measure alarm ranges default parameters
n
1
700 mV
2
3
4
5
6
and
Main Menu
CALIBRATION
Main Menu
SETUP
Main Menu
ADVANCED
Item
Temp. Measure min
Temp. Measure Max
pH Measure min
pH Measure Max
ORP Measure min
ORP Measure Max
to select one of the following functions:
and .
button.
Page 9 on 25
Limits
+ 10°C
+ 38°C
6 pH
8.0 pH
+450 mV
+850 mV