Descargar Imprimir esta página

Vicks WarmMist VH845E Instrucciones De Uso página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
TROUBLE SHOOTING
If your Humidifier is not working properly, refer to the following:
PROBLEM
Power switch is set to "on" and Power Light
is off
Power is "On" and no mist appears
Little or no mist is produced
Reset Light illuminated
Water overflows from Reservoir
Condensation forms around humidifier or
windows
PERFORMANCE SPECIFICATION
Tank capacity (litre): 3.8L
Duration - Full tank at minimum setting (hour): 24h
Ideal for rooms (saquare meter): 37m
8
POSSIBLE CAUSE
Unit not plugged in
No power at outlet
Water has not heated to boiling to produce
steam
No water in Tank
Unit is not level
Mineral deposits on Heater Element or Water
Tray
Water Tank is empty
Unit not reset after refill
Heating Element is covered in scale
Tank may be damaged
Tank Cap is not tight
Water Tray not seated properly
Mist Intensity is set too high for room size or
pre-existing humidity level
2
CORRECTIVE ACTION
Plug unit in
Check circuits, fuses, test outlet
Wait 3-4 minutes after turning on
Fill Water Tank
Place on a level surface
Follow Cleaning Instructions
Refill Water Tank
Follow Reset Procedure
See Cleaning Instructions
Check the Tank for leaks and replace if
necessary
Tighten Tank Cap
Check Water Tray and secure onto Base
Decrease mist output to low setting or
open door to the room

Publicidad

loading