Using the Scrambler
The radio's optional scrambler makes voice transmissions unintelligible to other radios without
a scrambler or that are not set to the same scrambler code, and descrambles incoming
scrambled voice transmissions if the transmitting radio is set to the same scrambler code.
If the scrambler is turned on, the radio can communicate only with other radios set to the same
scrambler code.
You must install an optional scrambler board in the radio and set a scrambler code (see "Set-
ting a Scrambler Code" on Page 39) to use the scrambler.
Note: You cannot use a WHAM wireless microphone to use the scrambler.
Hold down HI/LO/SCRAMBLER for 2 seconds to turn on the scrambler.
appears on
SCRM
the display. To turn off the scrambler, hold down HI/LO/SCRAMBLER for 2 seconds.
SCRM
disappears.
Using the Weather Function
The FCC (Federal Communications Commission) has allocated channels for use by the
National Oceanic and Atmospheric Administration (NOAA). Regulatory agencies in other
countries have also allocated channels for use by their weather reporting authorities. NOAA
and your local weather reporting authority broadcast your local forecast and regional weather
information on one or more of these channels. To hear your local forecast and regional
weather information, press WX/ALERT. Your radio scans through the weather band then stops
on the first active weather frequency, and
appears on the display. Rotate PUSH/SELECT
WX
to select another weather channel. To stop listening to the weather broadcast, press WX/
ALERT again. The radio returns to the last channel you tuned before you selected the weather
channel.
Using Weather Alert
To set the radio so it alerts you if it receives a weather alert, hold down WX/ALERT for 2
seconds.
appears. If the radio receives a weather alert, it sounds a tone and
blinks.
ALT
ALT
You can turn off the tone by pressing any key. To turn off weather alert, hold down WX/ALERT
for 2 seconds.
disappears.
ALT
Using SAME Alert
The National Weather Service precedes each weather alert with a digitally encoded SAME
(Specific Area Message Encoding) signal, then a 1050 Hz tone. The SAME signal includes a
FIPS (Federal Information Processing Standard) area code, and an event code that
corresponds with the type of alert being sent. You can configure your radio to operate in SAME
Standby mode, where it monitors a selected weather radio station for SAME alerts for areas
you specify. You can program your radio with up to 30 FIPS codes for the areas you desire.
The National Weather Service maintains a current list of FIPS codes at
http://www.nws.noaa.gov/nwr/.
If the radio receives a SAME alert tone, it checks the tone against any FIPS codes you stored
(see "Setting FIPS Codes" on Page 34 for more information). If the radio finds a match, it
sounds a tone and
flashes. Press any key to turn off the tone
ALT
Basic Operation
24