Publicidad
PRODUCT ASSEMBLY
FIG 1
Step 1. Take the two base cross
members (18) and push the 4 base
end caps (19) into the ends if not
already fitted and then cross them
over together.
FIG 2
Step 2. Remove the four screws
from the two base members and
attach the lower base pole (15) to
the base using a pozidrive
screwdriver (not supplied).
ENGLISH
FIG 3
Step 3. Unscrew and remove
the pole clamp (14 – shown in
step 2 above) and slide the
screw cover (16) down over the
adjustable and lower base pole
(13 & 15) until it is in place over
the screws.
Publicidad
