Publicidad
FIG 10
Step 10. Move the clips around the outside edge of the front guard outwards (see figure 10).
Step 11. Hang the front guard (1) over the top of the rear guard (5) (see figure 11).
FIG 13
FIG 11
Step 12. Bring the front guard down to meet the rear guard and push
the clips inwards until the front guard is fastened to the rear guard (see
figure 12).
Step 13. Finally fit the guard nut and screw (arrowed) through the holes
in the bottom edge of the guards and tighten with a suitable pozidrive
screwdriver (not supplied).
Note: this screw and nut must be fitted so that the guard cannot be
removed (see figure 13).
ENGLISH
FIG 12
Publicidad
